The CL-Series filter housing and fittings have been tested for performance under NSF Standard 42. Tests included Hydro Static Testing at 300 psig and Cycle Testing of 100,000 repetitions from 0 to 150 psig.
Service Flow Rate: 0.75 GPM (2.8 LPM)
Maximum Pressure: 125 PSIG
Temperature: 35-100o F (2-38o C)
General Installation/Operation/Maintenance Requirements
Note flow direction of filter.
For quick connect fittings, push scratch free tube end that has been cleanly and squarely cut into the fitting until it bottoms. Threaded fittings must be wrapped with Teflon™ tape before installation. Install Teflon™ taped fittings and tighten firmly. Use two wrenches to firmly tighten tubing.
Flush new cartridge with 5 gallons of water prior to use and check for leaks. If leaks occur, check tightness of tubing and fittings. If leaks persist, discontinue use and call your supporting dealer.
Replace cartridge when rated capacity is reached, or when flow becomes too slow.
Install in compliance with state and local laws and regulations.
The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your water.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.